Thorens Td124 Service Manual ~upd~

If the turntable was left engaged in gear for years while turned off, the stepped pulley will dent the idler rubber, causing a rhythmic thumping noise.

Based on the official documentation and expert practices, a proper service focuses on these critical areas: The Main Bearing

Anyone have a lead on the rare 1962 supplement for the early 110V export models? My motor has the black plastic junction box and the wiring shown in the common manual doesn’t quite match. thorens td124 service manual

Dress the edge on a lathe/drill with fine sandpaper, or replace it. Speed fluctuations or wobbling Clean steps with IPA; adjust height set-screws. Drive Belt Stretched, cracked, or slipping Replace with a premium, correctly tensioned belt. Calibrating the Eddy-Current Brake

Lubricate the pivot points of the idler arm lightly to ensure it engages the pulley cleanly without binding. Main Platter Spindle Bearing If the turntable was left engaged in gear

Submerge clean bushings in genuine turbine oil or Thorens-specific lubricants while heating them gently to force fresh oil back into the pores. The Idler Wheel Assembly

Check the rubber edge for flat spots, cracks, or hardening. Dress the edge on a lathe/drill with fine

Essential for identifying original parts and sourcing replacements.

Locate the bottom plate of the main bearing housing underneath the chassis.

To keep the Thorens TD 124 in optimal condition, it is recommended to perform regular maintenance tasks. The following schedule is suggested:

Aluminum clutch-action upper platter for instant stop/start