Minipro 6.85 Jun 2026

He hovered over the button.

If you are looking to purchase a new programmer, you should likely opt for the Go to product viewer dialog for this item.

The "6.85" in its name is a direct nod to its cubic capacity. It is positioned as a direct competitor to the Ender 3 series and the Prusa Mini, but at nearly half the price point of the latter.

With the release of , Autoelectric officially noted that the software fixed the GAL22V10 problem. While the release notes did not explicitly mention the GAL16V8, it was widely assumed that both GAL devices were now fully functional. Quick testing after applying the 6.85 upgrade confirmed that both GAL16V8 and GAL22V10 chips could be read and programmed successfully. minipro 6.85

Some "cloned" TL866 units may trigger a firmware update prompt in 6.85. Be cautious, as a failed firmware flash can brick the unit.

: Use the toolbar icons for Read (R) , Write (W) , Verify (V) , or Blank Check . The software provides real-time feedback, including pin-contact tests if the chip is seated incorrectly. Legacy Status and Alternatives

: This is the last version that works with the original TL866CS/A hardware before the manufacturer switched to the newer XGecu T56 and TL866II Plus series. He hovered over the button

The TL866 series of universal USB programmers, manufactured by XGecu (formerly known as Autoelectric), is one of the most widely used EPROM/EEPROM/flash programming tools among electronics enthusiasts, repair technicians, and retro computing hobbyists. These compact programmers connect to a PC via USB and are capable of reading, writing, and erasing thousands of different chip types—from legacy EPROMs in vintage arcade machines and pinball tables to modern flash memory chips in computer motherboards.

For TL866A owners, MiniPro 6.85 provides robust control over the 6-pin ICSP header, allowing chips to be flashed directly on a circuit board without desoldering.

Here’s a practical workflow for reading a 24C02 EEPROM from a BMW E46 airbag module: It is positioned as a direct competitor to

universal IC programmers before they were replaced by the TL866II Plus and the Xgpro software suite. The Legacy of MiniPro 6.85

Includes a built-in functional tester for 74/54 and 4000 series CMOS/TTL logic ICs.

MiniPro 6.85 balances simple, high-speed USB data transfers with clean, no-nonsense logic interface controls.