Ericsson Mini Link Cli Commands ★ Latest & Certified

To access the CLI, you can connect to the Node Processor Unit (NPU) via or SSH using a management IP address. Default Username : admin or admin_user . Default Password : ericsson or admin .

Mastering Ericsson MINI-LINK: The Definitive CLI Command Reference Guide

MINI-LINK# show interfaces summary # All ports, speed, admin/oper status MINI-LINK# show interface eth0 # Detailed: MAC, duplex, errors, drops MINI-LINK# show interface eth0 statistics # Rx/Tx octets, unicast, multicast, CRC errors

create vlan : Generates a new logical broadcast domain on the switch fabric. Network Routing and Management IP ericsson mini link cli commands

| Shortcut | Function | |----------|----------| | ? | Context-sensitive help | | Tab | Auto-complete command | | Ctrl+A | Move cursor to start of line | | Ctrl+E | Move to end | | Ctrl+K | Delete from cursor to end | | up/down arrows | Recall history | | do | Execute show command from config mode (e.g., do show version ) | | no | Negate a command (e.g., no interface vlan1 shutdown ) |

| Command | Function | | :--- | :--- | | | Enter global configuration mode from user EXEC mode. | | write mem | The most critical command for configuration. It saves the current running-config to the startup-config , making changes permanent across reboots. | | set switchport | Used to configure Ethernet switch ports, including VLAN membership, speed, and duplex. | | add vlan / remove vlan | Commands to create or delete VLANs on the Ethernet switch. | | sync vlan | Used to synchronize VLAN configurations, often applied via management platforms. | | no ... | Prepend no to any configuration command to disable or remove a feature. For example, no rsyslog enable disables syslog forwarding. |

These commands help verify the health and hardware inventory of the node: To access the CLI, you can connect to

: Use the enable command to enter Privileged Exec mode (indicated by a # prompt), which allows for configuration changes. Essential CLI Commands

Before running network modifications, you must establish an authenticated session and escalate your access rights. Initial Remote Access

traceroute [IP_address] : Maps the hop-by-hop network path to isolate routing loops or broken links. | | write mem | The most critical command for configuration

SET RADIO TXPWR=<VALUE>

To access the CLI, you can use standard terminal protocols like or SSH .

MINI-LINK# show running-config | include "vlan" # Show lines with vlan MINI-LINK# show interface eth0 statistics | exclude "0" # Hide zero counters MINI-LINK# show alarms active | begin "RSL" # Start output at RSL alarm